Skip to content
OkaysetOkayset

How much buffer time should you leave between appointments?

How to work out the gap you need between appointments for cleanup, travel or notes, and how to set it so customers can't book you back to back.

Scheduling problems & fixes3 min read

Your buffer should be the time your cleanup, travel or notes actually take after each service, plus a few minutes of slack. Then set that gap in your booking tool, per service, so customers can't book you back to back.

What is buffer time for?

A buffer is time blocked before or after an appointment that customers can't book. What goes in it depends on your work:

  • Cleanup and reset: sterilising tools, changing towels, sweeping up, putting the room back.
  • Travel: the drive to the next customer, for anyone who works at customers' homes or cars.
  • Notes and admin: writing up what you did, taking payment, booking the next visit.
  • Setup: preparing a room or a product before a particular service starts.

Without it, every small delay pushes into the next appointment, and the last customer of the day pays for all of them.

How do you work out the right amount?

Measure it rather than guess. For a week or two, note how long you spend between finishing one appointment and being ready for the next. Do it per service, because a quick trim and a full colour don't leave the same mess.

Then add slack for the things you can't plan, like a chatty customer or traffic. Cover a normal bad day; the worst day you've had is the exception.

For mobile work, look at drive times at the hours you actually work, not at midnight. If your jobs are spread over a large area, the buffer has to cover a typical drive, and your service area decides how long that is.

Should the buffer go before or after?

Many services only need a buffer after: cleanup and travel happen once the appointment ends. A buffer before makes sense when a service needs preparation that can't overlap the previous appointment, like heating equipment or setting up a treatment room.

If you use both, remember they add up between two appointments: 15 minutes after the first plus 10 before the second is a 25-minute gap.

What about the start times you offer?

Buffers interact with how often appointments can start. Say a 45-minute service has a 20-minute buffer, and appointments can only start on the hour or half hour. A 9:00 booking blocks you until 10:05, so the next possible start is 10:30, and those 25 minutes sit empty.

Line up the service length plus buffer with your start times where you can, so you don't create small gaps nobody can book.

Is a buffer wasted time?

It's time you'd spend anyway; the buffer just stops customers booking into it. If your buffers seem too long, keep the same notes you used to set them for a few weeks: if you're regularly ready early, shorten them in small steps.

Setting buffer time in Okayset

In Okayset each service has a Buffer after and a Buffer before, under Services. Customers never see buffer time as free time. Start times every sets how often a service can start; leave it empty to use the service length.

If an exterior wash takes 90 minutes with a 30-minute buffer after, a 9:00 booking blocks 9:00 to 11:00, and the next customer can book from 11:00 at the earliest. To actually offer 11:00, set Start times every to 30 or 60; left empty, this service starts every 90 minutes (9:00, 10:30, 12:00 if your day starts at 9:00), so the next free start would be 12:00.

A new buffer applies to new bookings and to appointments you move; existing ones keep the old gap.

Buffers are checked on Okayset's server every time someone books, so they can't be skipped. When you move an appointment in the dashboard, the new time is checked against your buffers too. The details are in services, buffers and prices, and the mobile detailing page shows how buffers work as travel time.

Written with AI assistance and checked against Okayset’s own product documentation in an automated review. Updated November 2, 2026.

More in Scheduling problems & fixes